SP-800A

Specifications:

Model SP-800A

Motor
1/4 h.p. (0.20kw), grease packed ball bearing, air-cooled, 110V/60Hz, 220V/50Hz, Single phase

Controls
Spar Mixer controls are front-mounted to give easy access in cramped kitchen environments. The following controls are standard on all Spar Mixers: separate start and emergency stop buttons so operators can shut down the mixer immediately in an emergency situation, a 15-minute timer which shuts off the machine after set time has elapsed, and thermal overload protection

Cord and Plug
Single phase are hard wired

Transmission
Heat-treated, hardened alloy, precision milled gears operate with planetary action. Gears are packed in a long-lasting, high pressure grease. Planetary gears are driven by an oversized cog-wheel, which is in turn driven by a cogged belt powered by the motor drive shaft. Cogged belt is a long-lasting, rugged fibre/rubber composite. This unique design yields high-torque mixing power while avoiding the high cost encountered repairing direct-drive transmission components.

Speeds:
1. 1st gear 132 rpm
2. 2nd gear 234 rpm
3. 3rd gear 421 rpm

Bowls and Agitators
Standard equipment includes a 8 Qt. (7.6Litres) high quality stainless steel bowl, dough hook, flat beater, and whip. A sturdy hand lever on the body column raises and lowers the bowl as well as locking in place at the top and bottom positions.

Finish
White epoxy enamel

Shipping Information
N.W. 25 kgs
G.W. 27 kgs

Size: (L x W x H)
47cm x 28cm x 58cm

Cartons are affixed to an undersized skid (pallet), the weight and diminsions of this skid are not included above and may vary from shipment to shipment.